Automatic Electric Bakhoor & Incense Burner, Lubaan
Details: Automatic Electric Bakhoor Burner,
Complete with UK 3-pin plug.
Stainless Steel Body
Made in India.
Description:
Probably the best quality Electric Bakhoor burner on the market with automatic(thermostatic) setting. This is an attractive burner made from stainless steel,with removable lid tray for easy cleaning. Fitted with UK 3 pin plugs.
Has a dial setting so heat can be adjusted on high or low setting. Can also be per-heated once plugged in. Strongly recommended to start on a low setting.
Size: 13 x 9 cm diameter (excluding detachable handle),
Fitted with a 3-pin fused Plug,
Voltage: 220 - 240V AC for use in the UK
=================================================================================================================================
UsingElectric Bakhoor Burner : Basic advice on using the Electric Burner.[Remember this is heated Burner]
Always start on a lower temperature around 20-30 for most Incense and resins.You can even go down to setting 10 to begin with. Let the incense gently warmup and release its scent. When the incense material darkens and smokes, orpreferably just before, turns the heat off. It will stay warm and keep workingfor quite awhile. Don't let the incense burn completely, when it begins to turndark the fragrance is spent.
The "Supreme" electric incense burner (withhandle) is thermostatically controlled to enable you to use it to burnmany different types of fragrances - incense resins and gums, powdered incense(Bakhoor), wood chips and powders, soft and hard dhoops,simmering granules, herbs, flower petals, fragrance oils etc.
Thermostat Settings : The best setting of thethermostat control will depend on the type of material being burned, and yourown personal preference… generally speaking, a higher temperature setting willproduce more smoke, whereas a lower setting will give a softer (and moremellow) fragrance. Initially, you should start on a low setting, then graduallyincrease the temperature a little at a time until you find the level you likebest.
We recommend that for most wood and resin blendsthat you set the temperature no higher than ' 40' and as low as '10' fordelicate blend.
We recommend lowersetting but don't be afraid to experiment to achieve the best result!
The burner should not be used at settings above'70' for extended periods of time, as higher settings will shorten the life ofthe heating coil.
Instructions& Safety Advice on using the Electric Incense Burner:
TheElectric Burner is very effective once the simple instructions arefollowed!
---Alwaysplace the Burner in a safe place away from children.
---Press a single layer of silver foil into the metal bowl.
---Place incense woods (Oudh) or resins onto the foil. Using silver foilmakes cleaning a lot easier.
---Plug it in and turn it on by adjusting the thermostat control knob, the redlight shows that the power is on.
---Let the incense remain on the hot surface of the bowl until it has releasedall it's fragrance or has turned dark. Woods and resins may vary but since thetemperature is controlled it will not burn up or flame.
---Do not re-use the foil. Dispose of it with the incense residue whenthe Burner cools down or remove it with a pair of tongs or pinchers. It isbest to use a fresh foil with each use.
---To move the Burner while it is hot, hold it by the handle. Because of therisk of fire or injury, never leave the Burner unattended whilst in use, especially with children in the vicinity.
---Please ensure that you turn the thermostat control to the "off"position and unplug the Burner after use.
